toreautos.blogg.se

1. ATV OFFROAD FURY 1 TUTORIAL DRIVER
2. ATV OFFROAD FURY 1 TUTORIAL FULL
3. ATV OFFROAD FURY 1 TUTORIAL FREE

ATV OFFROAD FURY 1 TUTORIAL FULL

Here is a link to help you out this is not my site and full credit goes to the owner of site. If it looks like it has waves or holes and cracks it means you have a cold solder joint and must reheat and apply flux with a small amount of solder to fix it. You want the solder to look as shiny as possible and smooth. After you solder check the solder joints for cracks, uneven and dull surface.

ATV OFFROAD FURY 1 TUTORIAL FREE

Any time you apply heat to solder joints you want to use flux to keep them clean and free of oxidized material. Put the solder wire to the tip of iron that is touching the wire and contact and not on top of the iron tip. You want to make sure you touch the wire and the contact you are soldering to as to transfer the heat to both items at the same time to make the solder flow. The key to soldering is to use the right amount of heat, solder and time you hold the iron to what your soldering to. Clean the surface by applying flux to it.The surface will be oxidized and will not let you transfer heat or solder to the surface. Now mach the pin-out to the weirs to the contacts and put flux on the contact you want to solder to. Tinning the wire is just applying a small amount of solder to the wire as to hold the strands together and make it easier to transfer the heat and solder to the contacts. Twist the wire and put flux on the surface you want to solder and tin them. Strip the wire shielding off a bit longer than the size of the contact you want to solder. When you go to store the iron apply a small blob of solder to the tip to keep it from oxidizing. Every time you go to solder Clean the tip off and apply fresh solder to it not a lot just enough to cover the tip when you want to solder. You have to clean the tip off with a wet sponge but not soaked in water just enough to get it wet. Once it is hot enough to melt the solder apply the solder to the tip and let is set there until you want to solder. To get the solder iron ready you need to heat it up. Also if you don't have vary much experience soldering i would also recommend getting a new cord for the fact you can cause more damage than good. If you don't have any of thous supply's it would be cheaper to buy a new cord. To reassemble your PS 1 console back together follow the above steps in reverse order.Ĭompare your new replacement part to the original part You might have to transfer the remaining components or remove adhesive backings from the new part before installing.įirst you will need a pin out of the adapter.ġ: Solder with rosin core thin solder would be bestģ: Flux to clean the surface you want to solder toĤ: Sponge to clean the tip of solder iron

Step five: Lift out the outer edge of the power supply slightly, and then rotate the whole entire power supply away from the small clip on its inner edge to remove the power supply.

Step four: Now remove the power supply and then remove the 2 14 mm-long Phillips #1 screws securing the power supply to the bottom of the case. Step three: Unplug the power supply and then gently pull out the power supply cable straight up and out of its socket on the power supply to disconnect it. Lift the top cover straight up to remove it. Step two: While holding the top and bottom halves of the console together turn the PS 1 console back over.

ATV OFFROAD FURY 1 TUTORIAL DRIVER

Step one: Open up the PS 1 console with a Phillips head screw driver and turn the console upside down and remove the 5 15.8 mm-long Phillips #1 screws.

With the 5501 and the 7001 and for the 9001 the process might be slightly different. Before you start make sure that the console is turned off and unplugged before you begin the process.